Svenska ElektronikForumet

Kod: Markera allt

/*
  Analog input A0 A5, Digital pin13 output, 
  A1 A4 on
 */

// These constants won't change.  They're used to give names
// to the pins used:
int led = 13; 
const int analogInPin = A0;  // Analog input pin that the potentiometer is attached to
const int analogInPin5 = A5; // Analog output pin that the LED is attached to
const int analogOutPin1 = 1;const int analogOutPin4 = 4;
int sensorValue = 0;int sensorValue5 = 0;        // value read from the pot
int outputValue = 0; int outputValue5 = 0; 

void setup() {
  // initialize serial communications at 9600 bps:
    pinMode(led, OUTPUT);   
}
void loop() {
  // read the analog in value:
  sensorValue = analogRead(analogInPin); sensorValue5 = analogRead(analogInPin5); 
  // map it to the range of the analog out:
outputValue = map(sensorValue, 0, 1023, 0, 55);  
outputValue5 = map(sensorValue5, 0, 1023, 0, 55);
  // change the analog out value:
  analogWrite(analogOutPin1, 255);  analogWrite(analogOutPin4, outputValue);
  
  digitalWrite(led, HIGH);   // turn the LED on (HIGH is the voltage level)
  delay(outputValue+50);               // wait for a 1000=second
  digitalWrite(led, LOW);   // turn the LED off by making the voltage LOW
  delay(outputValue5+50);               // wait for a 1000=second
    
}